Pudin,220V Electric Instant Heater,Supply Hot and Cold Water,Stainless Hot Water Tap with LED Digital Display for Home Facilities(British Plug)
| Weight: | 1.22 kg |
| Size: | proudct |
| Dimensions: | 32 x 9 x 26 cm; 1.22 Kilograms |
| Model: | ET-A3287 |
| Part: | ET-A3287 |
| Colour: | Silver |
| Batteries Required: | No |
| Batteries Included: | No |
| Manufacture: | Pudin |
| Colour: | Silver |
| Dimensions: | 32 x 9 x 26 cm; 1.22 Kilograms |
| Size: | proudct |
Like many others, I fitted this in my garage utility where I only have a cold water feed. It’s spot on, the water get’s reasonably hot if you reduce the flow slightly. It’s by no means a trickle when you do so for all those nay sayers telling you it’s rubbish, they’re wrong. Yes it’s not like your kitchen tap pressure for hot water but come on, did you really expect it to be for 60? It does a great job and I definitely would buy again.
Very happy so far does what it is supposed to do
I’ve had this for a few months, easy to install and does exactly what I needed it for. Really happy
Had this for almost two years now and its great. No issues at all.
Great piece of kit and works perfectly. Would highly recommend
Easy to install..with standed 15mm flexi pipe..spot o
We have several of these taps now and one had stopped working, so the supplier quickly sent out a replacement. The flow is slow as mentioned in other reviews but it does warm the water and is perfect for washing animal bowls in a small space.
Easy to install on my system which I’ve fitted isolation valves. It requires a 1/2inch double ended flexible hose pipe to attatch cold water feed. That’s why isolation value becomes important. Then noting the unit can draw higher than 3000 Watts, I’ve installed a breaker Fused socket and a 13a feed socket to ensure the fuse breaks if needed. But I may rewire into a 30A cooker socket and ensure one is used not both. This gives peace of mine but after each use I wall isolated the supply easily by flicking a switch. This adds extra safety.
Now the obvious negatives. This is a DIY fit, it’s a wire a plug fit also. If you can’t do that don’t buy.
The hot water feed is eliminated fitting this tap, but there is a way around this with a plan. So when, like us you’ve stored hot water, you can tap into it without needing it to be heated by this tap. So at the moment and for most ppl with no utility room, this will be the only source of water, be it cold or hot if required. It’s a thought to consider if you wish to reduce your consumption bill. The cold is as normal l, the hot has got upto 50degrees, but flow is slower to allow heating of water.
So to sum up. Good, but a compromise for some, adequate hot flow, no change to cold flow, need a flexible hose to connect. Need to monitor it under draw and ensure you’ve a fuse spur for safety.
I will submit an edit before January the end return date.
The pros. Hot water, no waiting for immersion heater. No storage of heated water, so save on. Energy.
If I’m honest, boiling a kettle for dishes may have been the real option. It would save on The 80 quid spent on the project at 6p a boil!
Updated review 21st Dec. Balencing up outlay cost, and its use, a kettle would be the sensible option. I decided to plumb into the hot water feed, ensuring that Im able to use solar stored hot. Its much better and does not affect the flow when cold. I use utility to fill kettle so no issues there
You only heat the water you need to use. We bought one to try it out and it worked well therefore we have bought a second one for the bathroom sink
Easy to fit. Looks amazing in the utility room. Very hot water in seconds. Just turn the tap on full on the hot, then bring it up again to the centre.
Bought this for kitchen, instant lovely hot water. Saves us not having to put immersion on. Only use immersion once a week now.brillia
Looks good heats up well easy to install.
Pleased with the price. Makes life easier and saves on gas and waiting for the water to get hot this is much quicker.
Very easy to fit and plumb in. Don’t be heavy handed on the on off though. It feels a bit less robust than a conventional tap valve. That said, this is a clever functional tap which is very efficient.
Hi Well i did have a problem with the tap and asked the seller for some info and the tap was not working well and they said it sounds like there was a fault with it So within 24 hours they sent a new tap and yes no fault Super service and would say to anyone thinking about this item just go for it its very good and very good service as well and that hard to find now days So thank you amazon for bing a good item for sale
Easy to install and is plug and play. No more boiling my kettle to get hot water and is cheap to run. Hope it will be reliable and long lasting. If it is then I will get another for my bathroom.
I’ve bought this model several times now (for different rooms) and I’m really happy with it. It can be a bit fiddly to tweak to the desired temperature when you first get used to it but it works really well. The temperature gauge is accurate – note it can get really hot which is great when I use it to wash dishes but I wear rubber gloves to protect my hands.
The flow rate changes as you adjust temperature but even at a low flow rate (for hotter water) it’s still adequate for kitchen sink tasks. Washing up dishes takes no time and I use far less water now too. No tank means it takes up less space and the hot water really is instant. It is a bit on the large size which is fine for kitchens. Still looking to find a smaller version suitable for a bathroom which is smaller. I’ve tried 4 alternative “instant hot taps” but none stood up to the finish, reliable temperature range or usability as this tap.
I recommend this product and I would buy again.
This tap was fitted for use in an under stairs toilet and sink. The single, cold feed and 240volt plug in power source made installation easier and operation more energy efficient than running from a distant boiler.
I can’t be fussed with boiling water – our kettle makes water hot in a minute so why buy a system that requires you to leave it on all day for three cups of coffee?
This just plugs into the cold water input and heats water within 5 seconds. What’s not to like?
We had a plumber install it and he added a plug to the wire so we can unplug it when we are not in the office and also have the added security of the fuse in the plug. There were mentions of some buyers experiencing smoke from the device so we thought it better be fused and unplugged when the office is empty. The cold water works without electricity.
The temperature is easy to adjust, cold at the top and warm when the tap is turned down. The display doesn’t light up until you are turn on the warm water and weirdly the warm water it hottest when the tap is closest to the cold, and gets colder the more you turn the tap towards the sink away from the cold. It seems the perfect handwashing temperature of 40 degrees is roughly at 45 degrees (picture 3) and it takes seconds to reach that temperature. Ours range from cold to 60 degrees.
The tap is neat but very tall, so water does splash a bit around the sink (picture 2), it would have been an idea to have designed the the heating thing to sit below the surface, so the tap was normal height (hence only 4 stars).
The plumber wanted to turn down the water pressure to avoid splashing, however when he did, the hot water couldn’t be adjusted and was 60 degrees all the time, so high pressure is needed to mix and cool the hot water to handwashing temperature…
We have used it for 3 weeks now and are very happy.
Fitted to a utility sink. Very easy to install.
Temp goes up to over 50deg C if you want it to!
Only been installed for a couple of days so I reserve comment on reliability
Need to solve a hot water tap problem this unit is actual very good
This is one of my little upgrades for this year I’ve installed it in place of a single cold water feed tap, plugged it in and voila, i now have hot water on demand for washing up, now all i need are people to come drinking in my garden.
Installation was rather simple as it’s just a normal setup except for the fact that it needs power, i placed a plug below and off to the side of my tap in order to avoid any potential issues with leaks etc…better safe than sorry. The water heats up quite quickly given instant warm water, it doesn’t give boiling water, so don’t expect to be able to make cups of tea out of the tap, but it’s warm enough to wash up in and use to pre-boil your water if you need a quick cuppa.
If like me, you have a space where extending your boiler to is not an option, then this is a great, compact solution (much better than those big chunky electric water heater in my opinion)
This is my third electric tap in my kitchen – the previous two failed for the above reason, so looking forward to seeing how long this one lasts.
Otherwise, it is a fairky sturdy tap, easy to install and not garish like the original ones.
Very well made and easy to install well worth the money
Got it fitted in my utility room where hot water does not gets. Well buid with clever system to get warm water. We are using it mainly to wash our hands and it does great for that. Space saving and looks nice, would buy agai
We used this tap in a downstairs cloakroom. It was ideal because the heating pipes did not need to be re- directed.
Amazing product, looks modern and was easy to install, the hot water function is brilliant and safe.
Would highly recommend
It took some time to install,but it’s not very difficult. You might need to buy a flexible tap hose to fits it, because it’s bigger than standard sink hole. Anyway,it works great and good price.