Rustins Quick Dry Varnish Clear Satin 1l
Rustins Quick Dry Varnish Clear Satin 1l
Rustins Quick Dry Clear Varnish
Rustins quick-drying, hard wearing coating for all interior woodwork, has the least effect on the colour of the wood. A tough and durable finish for all woodwork and cork. Apply 2-3 coats for the perfect finish. Low odour non-toxic and touch dry in 20 minutes, re-coatable in 2 hours. Clean brushes in water. Available in gloss, satin and matt finishes.
- For interior use
- Waterbased & quick drying
- Gloss, satin & matt
- Tough & durable
- Low odour & non toxic
 |  |  | |
|---|---|---|---|
| Shades | Clear | Clear | Clear |
| Gloss | ✓ | ||
| Matt | ✓ | ||
| Satin | ✓ | ||
| Available in all sizes | ✓ | ✓ | ✓ |
| Weight: | 544 g |
| Size: | 1L |
| Dimensions: | 11.61 x 11.61 x 11.99 cm; 544.31 Grams |
| Model: | AVSC1000 |
| Part: | AVSC1000 |
| Colour: | Clair Satin |
| Pack Quantity: | 1 |
| Batteries Required: | No |
| Batteries Included: | No |
| Manufacture: | Rustins |
| Dimensions: | 11.61 x 11.61 x 11.99 cm; 544.31 Grams |
| Quantity: | 1 |
| Size: | 1L |
| Volume: | 1 litres |
Did the job! Has a lovely finish and I didn’t notice any real odour when painting either.
Purchased this for interior door touch up on some recently installed doors & as far as I can tell is not for exterior use.
Touch drys quite quickly & brushes clean in cold water, very pleased with the size, quality & price.
Ideally needs a synthetic bristle brush that is intended to apply water-based finishes such as this; unless thoroughly washed after use, natural and animal bristle brushes will dry hard and need special chemical treatments to clean and make them usable; instructions and relevant data are on the pot.
The varnish is almost free of odours – there is a very light smell that does not travel far beyond the pot. Other than stirring and preventing drips or spillages, it could not be any easier to use.
This stuff is very easy to use, gives a good finish and doesn’t smell too strong. Good value too. Will use again.
A 500ml pot is enough to do one side of a pine door and frame with three coats with a decent bit left over.
Easy to wipe up any drips and also easy to clean brushes in water. I bought a brush marketed specifically as a varnish brush and I think that helped with application. I have now had 9 uses and cleans out of one brush with this stuff and it is still fine.
Caution that it can ‘lift’ and move water based stains even if they’ve been left for weeks to dry so makes sure you go with the grain and with care for the first coat if that’s your use case.