BW RCA Wireless Transmitter & Receiver for Car Rearview

BW RCA Wireless Transmitter & Receiver for Car Rearview Reversing Camera Monito
BW 2.4GHZ RCA Wireless Transmitter & Receiver for Rear Reversing Camera Monitor




Specifications:
- Receiver/transmitter frequency: 2370MHZ
- Power output: 100MW; Voltage: DC=12V
- Video IN/OUT: PAL/NTSC composite video signal
- Signal range: 100M (in jam-free open areas)
- Working TEMP: -20°C- +80°C; Receiver sensitivity: -85Dbm; Working current: DC=12V 200mA
- GPS power out: DC=5V 1.5A
- AV OUT interface: RCA jack
Dimensions: | 13.2 x 10.4 x 2 cm; 100 Grams |
Model: | BW-2.4G |
Manufacture: | BW Corp |
Dimensions: | 13.2 x 10.4 x 2 cm; 100 Grams |
Easy too install, unfortunately the picture quality is a bit fuzzy and it seems to reverse switch was unable handle the additional current requirement and failed after a few times of activating the system
Works fairly well. Used it to connect a reversing camera. It will always connect but sometimes the image gets interference so it will kind of like buzz across the screen, you can still see while you reverse so it’s not a show stopper. Might be obvious to some but when installing one is a receiver and one is a transmitter so make sure you have them the right way around.
A good kit although I have not got it working as yet as I am still trying to find a cheaper way of encoding the Mercedes Comand head unit to accept the signal.
Fantastic piece of kit.
Allowed me to fit a reversing cam into my car without running wires.
Connected TX to reversing light so only avctivates when reverse is engaged,
Brilliant solution.
Excellent for avoiding the job of pulling cables through the length of a motorhome. Well worth the cost for that reason alone and fine for the quality of the video sent. Thumbs up for this one.
BW License Plate Waterproof Car Rear View Camera Night Vision CMOS 135 Degree (E322)
and
BW 4.3” Color TFT Car Monitor Support 480 x 272 Resolution + Car Rear-view Mirror System Monitor, Mini Monitor for Car / Automobile.
Worked straight out of the box: no setup or configuration needed. Very easy: plug in & it works. No signal degradation at all at 3m separation.
The two appear similar, but are marked transmitter & receiver: make sure you connect them to the right device (transmitter to the camera; receiver to the monitor).