Systercol Helmet Anti-Fog Visor Insert Motorcycle Anti Fog
Systercol Helmet Anti-Fog Visor Insert Motorcycle Anti Fog Film – Universal Fit Helmet Visors Fog Resistant Film Clear Shields Lens Insert 27cm x 9cm
STEP 4
Use finger wuth soft fabric to press the glue around for the best ashesion.
SPECIFICATIONS
| Product | Anti-fog Visor Insert |
| Fit | Universal Fit for most helmet with or without Pinlock |
| Size | 27cmx 9cm（3.58″ x 10.7″） |
| Before Pasting | Make sure you are in as dust free environment as possible and do a great job removing fingerprints and or smudges. Don’t touch the inside of the lens until you have this insert film fitted. |
| Make sure place the anti fog insert film correctly when you are fitting it. The anti-fog visor needs to be positioned slightly lower as you may be looking through the lower edge of the shield to the centre. | |
| Repeated removal of the insert after pasting is not recommended. Also, once you’re done, let it sit for half hour or so. |
| Weight: | 50 g |
| Dimensions: | 32 x 12.5 x 1.5 cm; 50 Grams |
| Brand: | Systercol |
| Manufacture: | youli-3311s |
| Dimensions: | 32 x 12.5 x 1.5 cm; 50 Grams |
| Reference: | MHSF-002 |
I tried a lot of expensive sprays, also a lot of ways from the forums to prevent the visor from fogging up my motorcycle helmet . However I wasn’t very happy with the results, but when I decided to try this product I was really pleasantly surprised – a perfectly clear visor at a temperature of 2C.
Bought it as my Bell visor is prone to fogging up, particularly bad in winter and rain. Easy to fit, have used it for about 6 hours now and works a charm. Fitted a Windjammer touring to the helmet also which are known to contribute to fogging at low speed. Practically zero fogging even while urban filtering. Give your visor a good clean down with alcohol before fitting. Would recommend.
Brilliant! Never had an anti fog visor before, never will I be without again! It didn’t quite fit my visor as I got the tabs for the clip on ones, so I had to trim the visor a bit, carefully avoiding cutting off too much of the rubber seal. The included crosshair is pretty much useless as there is nothing to cross reference on the visor! But I managed nonetheless, it’s a bit fiddly, but it got stuck on in the end.
Left it 24hrs as stated and wend for a ride. Not once did I need to pop my visor, apart from the occasional times when it got too hot inside! It misted up nicely around the visor but nothing on it itself! Definitely worth the money , albeit slightly pricey.
Got two more for the wife and daughter!