When using ST-LINK to program STM32F103C8T6:

1. Set BOOT1 to 0 and BOOT0 to 1 to put the chip into the programming state;

2. Press the reset button to reset (STM32F103C8T6 is low level reset);

3. Set BOOT0 to 0 to enter the running mode;

4. Press the reset button to reset and start running the program.

STM32F103C8T6

• Package Type: LQFPN
• umber of pins: 48K
• ernel: Cortex-M3O
• perating frequency: 72MHzS
• torage resources: 64K Byte Flash, 20KByte SRAMI
• nterface Resources: 2x SPI, 3x USART, 2x I2C, 1x CAN, 37x I / O portsA
• nalog-to-digital conversion: 2x ADC (12-bit / 16-channel)T
• imers: 3 general timers and 1 advanced timerD
• ebug Download: Support JTAG / SWD debug interface to download, support for IAPR
• T9193: 3.3V regulator chip, the maximum output of 300mA

ST-LINK V2

• Input voltage (USB): 5V
• Output Voltages: 3.3V, 5V
• Interfaces: SWIM, SWD
• Connectors: USB, 10 pin (molex type)

FT232RL Serial Converter

• Operating Voltage: 3.3V/5.5V
• With 500MA self-restore Fuse
• RXD/TXD transceiver communication indicator
• Support Win95/98/98se/ME/2000/XP/win7 32bit 64bit /Vsita/, do not Support Win8

NOTE:

• Download the program and debug it using Platform IO, the chip’s ID has a little different and requires some adjustments in PlatformIO (Change a line in the stm32f1x.cfg file to set _CPUTAPID 0x2ba01477 and added upload_flags – =c setting CPITAPID 0x2ba01477 to plaformio.ini), programming a simple blink test in release mode worked using the ST Link clone, as did a debug build with a breakpoint.

Package Includes:

1 x ST-Link V2 Programmer

1 x STM32F103C8T6 ARM development board

1 x FT232RL serial converter

1 x Mini USB cable

1 x Micro USB cable