AMANSON White PC CASE ATX 5 PWM ARGB Fans Pre-Installed, USB
AMANSON White PC CASE ATX 5 PWM ARGB Fans Pre-Installed, USB 3.0 Mid Tower Computer Case with Full View Dual Tempered Glass, Gaming PC Case,G8
AMANSON White PC CASE ATX 5 PWM ARGB Fans Pre-Installed, USB 3.0 Mid Tower Computer Case with Full View Dual Tempered Glass, Gaming PC Case,G8
Had a few lian cases and this is basically the same as the vision but nearly half the price easy to build plenty room for cable management and good quality, like how the glass door opens on hinge one tab to pull open very quick for easy access
Only inconveniences I can think of is the motherboard (ATX) is quite close to the bottom that’s made it a tad cramped next to the fans and case connection to motherboard. Also the gpu panel on the back needed the hinges adjusting so the gpu support bracket could fit in place.
Overall very happy with the case though!
I wanted to fit my 360AIO as intake front (side) but radiator is too big for it so make sure you know the measurements. You have 38cm and my radiator is 40cm however I had no issues fitting it as exhaust on the top panel. I just wished this was displayed instead of just the external measurement! Orher than that it’s good and cheap, I also had to renounce to USB 3 top panel as you won’t be able to fit bottom fans otherwise unless you have a slim version when using it with ATX.
My old case didn’t quite cut the mustard so I took a punt on this case and I’m pleased I did.
The info on the sellers page states 360mm GPU max and elsewhere it states 400mm. I can confirm that 400 + mm is correct.
I’ve used a Cooler Master Vertical GPU Holder Kit V3 in this build which does require a small mod to the PCI bracket at the back of the case for cable connection. Basically cut out a separator bar between the 1st and 2nd PCi slots. More if you use more of the DP or HDMI port on the back of your GPU.
Overall my GPU and mount is about 380mm .
I must admit I was a little concerned about how floppy the case seemed to be without the front and side glass panels in place . However the more I screwed in the stiffer it became (ooh er missus).
The space at the back of the case is brilliant .Easily accommodated all of the cables and plenty of fixing points for zip ties.
No sharp raggy edges .
The only 2 things I can complain about is there are no rubber grommets for the cable routes into the case from the rear compartment and there are no Black screws in the screw pack.