REYLAX LED Driver 12V 30W, LED Transformer 240 to 12V DC
REYLAX LED Driver 12V 30W, LED Transformer 240 to 12V DC 2.5A, Constant Voltage LED Power Supply Adapter, Low Voltage Transformer Converter for Strip Light, Downlight and G4, MR11, MR16 LED Light Bulb
From the brand
| Weight: | 80 g |
| Dimensions: | 9.4 x 4.3 x 2.3 cm; 80 Grams |
| Model: | DT-NS12V-30W |
| Part: | RX-S12V-30WP1 |
| Pack Quantity: | 1 |
| Batteries Required: | No |
| Batteries Included: | No |
| Manufacture: | REYLAX |
| Dimensions: | 9.4 x 4.3 x 2.3 cm; 80 Grams |
| Quantity: | 1 |
5.0 out of 5 stars Works ans as described
Works and no problems Good if you only have a small space available.
5.0 out of 5 stars Robust little drive
Used do replace a broken driver in a bathroom mirror, smaller that the original so fitted ok.
Worked a treat.
Works perfectly
Small size was great for an LED strip mounted inside a cupboard. Runs cool and silent. Would have been 5 stars but the terminals are very fiddly for 1mm T&E cabling due to location.
5.0 out of 5 stars Good produc
Good quality, does what it is supposed to do. No problems
5.0 out of 5 stars Perfect size
Fitting in a confined space is easily done as the size is perfec
Good compact power supply
I purchased this to run some led strips, and it does the job well
Its compact and easy to fit, although some consideration must be taken to the cable used
You need to use 0.75mm 2 core flat flex to fit into the mains terminals as they are so tight, and it is not permitted to have single insulated cables exposed unless the whole driver is secured in a proper electrical enclosure, as per the wiring regulations.
Using the small flex you are able to fit the outer insulation within the screwed terminal which means you can mount this as it is without any risk of shock.
The driver is double insulated so no earth is required.
The outgoing 12v supply can be connected to single core cable if required as there is no shock risk at that voltage.
It would be ideal for Extra Low Voltage down-lights or led strips as is compact enough to fit through a mounting hole.
Overall good bit of kit, time will tell how long it lasts
5.0 out of 5 stars Works well
Needed additional lighting indoors and this was bright and simple to move around
This transformer works fine. The only issue I have with it, in common with most manufacturers of these type of products, is that the terminal size for the incoming mains connection is woefully small necessitating the installation of a short lead with a 0.75 mm conductor to interface between mains connection and the transforme
5.0 out of 5 stars Ideal replacement for IKEA faulty unit of 10 yrs old
Small compact and easy to install. Our IKEA 10 yr old wardrobe strip lights now work once more
Flicker free LED`s
Replaced low volage halogen lamps with LED and had lots of flicker. Changed the transformers to these and now flicker free – do agree with some other posts that the in and out terminals work best if the wires have solid ends to push in.
4.0 out of 5 stars Works well
Works well as described, however the accompanying instruction could really be improved
Does the job, good value, but fiddly cable connectio
Used the 15W and 30W versions of this to replace fluorescent under-cupboard lights in the kitchen. Seemed good value and does the job, barely gets warm and only a very slight buzz/whine – inaudible in any normal conditions.
Only complaint is the screw terminals are set down below the cable entry which makes inserting cables quite difficult. They seem to be designed for stranded, but stranded cable mushes up rather than pushing into the terminal. I ended up crimping on bootlace ferules, then trimming and bending slightly.