Creality Stepper Motor, Official 3D Printer 42-40 Stepper
Creality Stepper Motor, Official 3D Printer 42-40 Stepper Motor 2 Phase 1A 1.8 Degree 0.4 N.M Stepper Motor for 3D Printer Extruder, Original Stepper Motor for CR-10 Series and Ender-3 Series E-Axis
From the brand
| Weight: | 340 g |
| Dimensions: | 11.6 x 8.3 x 6.4 cm; 340 Grams |
| Part: | CL-GJX-40DJ |
| Colour: | A-42-40 Stepper Motor |
| Batteries Required: | No |
| Batteries Included: | No |
| Manufacture: | Creality 3D |
| Dimensions: | 11.6 x 8.3 x 6.4 cm; 340 Grams |
| Reference: | CL-GJX-40DJ |
I ordered this to use it with my new dual gear extruder. Arrived on time and came in original creality box. Works really well. Remember to calibrate e steps after installatio
Super schnelle Lieferung. Wie meistens bei Amazon. Kostengnstig und von sehr guter Qualitt. Alleine vom Gewicht merkt man das er hochwertig ist. Eingebaut und Takt gemessen und was soll ich sagen. Passt was nicht selbstverstndlich ist. Ich brauchte den Extrudertakt nicht neu einstellen. Top
Bon moteur conforme l’original
Remplac aprs 2 ans d’utilisation intense de mon imprimante Ender 3v2
Rcemment j’ai expriment des problmes d’extrusion et j’ai pu constater qu’en fait le galet d’appui du fil tait compltement gripp, ce qui la longue tu ce moteur d’extrusion galement…
Avec ce moteur neuf et un galet neuf retour la normale ! parfait !
I bought a cheaper pattern part, “guaranteed compatible” only to find that two of the wires were transposed! I returned it, and bought a genuine creality. No issues, and you know it’s going to fit perfectly.
All working great for a extruder that required a longer shaft.
I upgraded to a direct drive plate but my original Stepper shaft was too short to work.,
Excellent and in stock in UK
There isn’t too much to say about this other than it is a direct replacement for the one that busted on my ender 3v2, I however am using the larger of the two but for my Z, it’s already done over 100 hours and going strong just as I would expect, A+ and recommended
Had to buy this as I went to a direct drive setup and could not get the old / original pressed cog off the shaft! I have installed this replacement without any issues at all.